Examine the Simulation Data Logging Configuration of a Model
Many analyses that you can perform using Simscape™ Electrical™ require a simulation log variable in your MATLAB® workspace. The model in this example is configured to log Simscape data for the whole model for the entire simulation time. To examine the data logging configuration of a model:
Open the model. At the MATLAB command prompt, enter
model = 'ee_rectifier_power_dissipated'; open(model)
Open the model configuration parameters and then, in the left pane, select Simscape. Relevant parameters are:
Log simulation data — Data logging is enabled for the whole model because this parameter is set to
Allso you can calculate the power dissipated by any of the semiconductors in the model.
Workspace variable name — This parameter, which is also referred to as the name of the simulation log variable, is specified as
Limit data points — You can calculate the power dissipated for the entire simulation time because the option is not selected.
Alternatively, you can determine the Simscape data logging configuration without opening the model configuration parameters,
by using the
get_param function. For example, for the
ee_rectifier_power_dissipated model, to determine:
If all, some, or no data is logged, at the MATLAB command prompt, enter
ans = 'all'
The name of the Simscape logging variable
ans = 'simlog_ee_rectifier_power_dissipated'
If the option to limit data-points is on or off
ans = 'off'