xPC Target error: ERROR: EtherInit: EtherID 1: Binning Error 776

I'm getting the error listed above when trying to execute an xPC model. The same model runs fine if I remove one of the Ethernet Initialization blocks. Interestingly, the block I remove is not the one with the EtherID listed in the error (the error always gives EtherID 1).

Does anyone else have experience with this issue?

Answer 1

[Chethan Pandarinath]

It turns out this issue was solved by increasing the Network Buffer sizes under the Buffer Mngmt blocks. The model ran without issue after setting the Buffer pool sizes to: [8196 512 4096 65535]

They were previously set at the default values for the Buffer Mngmt block.

Side note: because this is a concurrent model, with multiple model reference subsystems, there are Ethernet Initialization and Buffer Mngmt blocks within multiple model reference subsystems. To get the model to work, I had to change the pool sizes in all Buffer Mngmt blocks to match the above values.

This is under Matlab R2012b.