Adding header and terminator to PX4 serial receive block

2 visualizaciones (últimos 30 días)
Ali Barari
Ali Barari el 3 de Dic. de 2021
Comentada: Anthony Comer el 29 de Sept. de 2023
Hi,
I want to send data with header and terminator to Pixhawk board over radio telemetry. In the current version, PX4 serial receive block doesn't accept header and terminator, so i don't receive data on the Pixhawk 4 properly.
How can get the PX4 serial receive block to accept header and terminator?
  1 comentario
Anthony Comer
Anthony Comer el 29 de Sept. de 2023
Ali,
Were you ever able to receive the data on the Pixhawk successfully?

Iniciar sesión para comentar.

Respuestas (1)

Arun Mathamkode
Arun Mathamkode el 6 de Dic. de 2021
PX4 Serial read and write blocks enables basic data write and read through Pixhwak serial interface. Although, the header and terminator is not supported out of the box, you can always model the header or terminator logic around these blocks. Have a look at this example, which implement a header logic with the PX4 serial blocks.
  4 comentarios
Ali Barari
Ali Barari el 8 de Dic. de 2021
Thanks Arun,
I installed both "Simulink Support Package for Arduino Hardware" and "Embedded Coder Support Package for Texas Instruments C2000 Processors" which should have the Protocol Decoder block. After i installed them, i couldn't find that block in my simulink library. It's strange!
Arun Mathamkode
Arun Mathamkode el 9 de Dic. de 2021
Editada: Arun Mathamkode el 9 de Dic. de 2021
This block is only available from R2021b. Are you using any older release? As per the documentation it should be avaialable in the ' Common' library under Simulink Support Package for Arduino Hardware. Also check if it is coming up when you search for it in the Simulink canvas.

Iniciar sesión para comentar.

Productos


Versión

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by