Deployment of Simulink designed controller to Pixhawk Cube Orange for a generic qadrotor UAV
6 views (last 30 days)
Show older comments
Tanay on 19 Dec 2022
Commented: Ankur Bose on 5 Jan 2023
I wanted to implement my designed controller in PX4 so to understand the process, I was trying to implement this example provided by MATLAB. I was able to perform HITL simulations and was trying to implement the controller on an actual quadrotor. For that I followed a similar procedure and disabled 'Enable HITL Mode' in the Model Configuration paramters.
The controller model used in this MATLAB example reads the waypoints from QGround Control mission as shown in the figures. So I wanted to know if the simulink controller is used only in mission mode and not any other modes like manual or stabilised mode? Does pixhawk use the default PX4 control algorithm in Manual mode?
Manoj Velmurugan on 20 Dec 2022
Edited: Manoj Velmurugan on 20 Dec 2022
When you run the hardware setup screens from MATLAB, the inbuilt controllers get removed from the build process (by default). They no longer run in PX4.
Simulink controller runs irrespective of the selected mode from QGC.
For stabilize functionality, you can try deleting the high level navigation control loops in that model. Use Radio Control Transmitter block to get the RC inputs and set the roll, pitch, yaw setpoints.
Ankur Bose on 5 Jan 2023
We have validated the Simulink controller model in this example only for mission mode. That being said, the controller should work in manual mode as well. Can you elaborate on the changes you did on the Simulink model for manual mode and what is the behavior you see? What do you mean when you say QGC is not publishing any active waypoints? How are you seeing that?
Find more on PX4 Autopilots in Help Center and File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!Start Hunting!