Block diagram window keeps popping up when running Simulink.

1 visualización (últimos 30 días)
Ron McNabb
Ron McNabb el 15 de Mzo. de 2023
Respondida: Amith el 29 de Mzo. de 2023
I am running a script that calls a Simulink model within a loop like below. Every time it calls the model the block diagram for the model pops up. This makes it difficult to do anything else since the block diagram comes to the front every 10 seconds. Is there can way I can prevent this from occurriing?
for = 1:N
simOutputs = sim(simIn);

Respuestas (1)

Amith el 29 de Mzo. de 2023
As per my understanding you want to prevent the Simulink model window from popping up when your for loop runs and calls the block. To prevent this you can set the SimulationMode parameter of the Simulink model to 'accelerator' or 'rapid-accelerator'. This will run the model in an accelerated mode, which will not show the block diagram when the model is called. You can set this parameter using the following command:
set_param('model_name', 'SimulationMode', 'accelerator');
set_param('model_name', 'SimulationMode', 'rapid-accelerator');


Más información sobre Modeling en Help Center y File Exchange.





Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by