how can I make the signalbuilder run

can I run the signalbuilder through Matlab script's ? if yes, so how ?

thank you

Answer 1

[Abhiram Bhanuprakash]

Hi Ahmed,

You can use the sim command to run any Simulink model using command line API. Documentation here

So, you can create a Simulink model with a signal builder block and then use sim to run it by command line.

You can also set block parameters of a Simulink block using set_param. You can query them using get_param. You can use these functions on the signal builder block to set or query block parameters.

Hope this helps,

Cheers!

Abhiram

[Ahmed BOULMANE]

thank you Abhiram,

the problem is that I'm looking to make run a single group among those that exist in the signalbuilder, knowing that we have 60 groups.

Answer 2

[Ahmed BOULMANE]

Heeeeelllppp !!

Answer 3

[Anthony Poulin]

Hello,

Do you want to select a specific group of your signal builder?

If YES, use the command: signalbuilder(block, 'activegroup', index) which sets the active group with the index that you specified. Then run your simulation, with the "sim" command (like Abhiram says).

[Ahmed BOULMANE]

thank you :) it works good (y) otherwise, have you any idea about how can I load the index from a .txt file