No deploy to hardware button in simulink (using the F2837xD with ccsv6)

4 visualizaciones (últimos 30 días)
Hi All, I'm interfacing the TMS320F28379D with MATLAB 2016a using the ccsV6. I have several problems and I'm unable to generate code and interact with the hardware board (ControlCARD). In the configuration parameters toolbar I haven't the line : Code Generation system target file : ert.tlc and the tab Code Generation is absent.
Also in the simulink windows the deploy to hardware button is missing. I think something is missing but I don't know what. The device is well connected and the target configuration is OK. Maybe the setup is imcomplete????

Respuestas (1)

Gayatri Menon
Gayatri Menon el 10 de Abr. de 2018
Hi,
If you are using TI C2000 Support Package, it requires MATLAB Coder, Simulink Coder and Embedded Coder to work. Please refer the below link for more information:
Could you please check if you have the above-mentioned products installed in your system.You could check this by executing the following commands in MATLAB command Window
>> ver
Thanks

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by