Realising a torque rod getting a PWM current signal and controlled with PID Controller

2 views (last 30 days)
I am trying to develop a 3 axis magnetorquer on simulink. I wish to have a 3 axis control by giving desired RPY(Roll, Pitch and Yaw) values. This will be done by using a PID control block followed by a PWM block. But I am unclear as to how to integrate them.
Also it is unclear as to how to make a physical model of the orthogonal rods in simulink, so that when I give currents, the entire configuration rotates accordingly.

Answers (0)


More Answers in the  Power Electronics Control

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by