How can I tune the PID parameters of the PMSM Field-Oriented Control block?

6 visualizaciones (últimos 30 días)
How can I tune the PID parameters of the PMSM Field-Oriented Control block?
I can use the auto-tuning feature in Simulink to tune regular PID control blocks, but I cannot figure out how to tune the PID parameters of the PMSM Field-Oriented Control Block.
I tried tuning the parameters by hand, but this takes too long and produces unreliable results.

Respuesta aceptada

MathWorks Support Team
MathWorks Support Team el 22 de Jun. de 2019
Editada: MathWorks Support Team el 21 de Jun. de 2019
Since the PMSM Field-Oriented Control Block is an advanced controller that is not supported by the auto-tuning workflow, there are currently limited options for tuning the PID parameters.
You can perform a parameter sweep or try using the Autotuner blocks to speed up the process of manually tuning the parameters. Here are some topics that may help you tune your controller.
Tuning power electronic controllers with PWM involved:
Autotuner Block tuning:
Short video describing auto-tuning:
Closed Loop Autotuner Block:

Más respuestas (0)

Etiquetas

Aún no se han introducido etiquetas.

Productos


Versión

Aún no se ha introducido una versión.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by