Failed to program the device of the Zedboard Using matlab R2019b

Hi.

I am using MatLab R2019b(academic use) and following a video- Run a Simulink Model on Zynq: ZedBoard Set Up” showed on MathWork with an example of “led_blinking” to setup my Zeboard FPGA board(zynq 7000).

1. When I was running the step 4.3 – Build FPGA Bitstream, a window of Command Prompt was openned simutaneously and the results of the HDL Workflow Advisor was showen “passed” showed as the figure. Is that correct?
2. When I was running the step 4.4– Program Target Device, the results shows “Failed Too many output arguments”. How can I fix the problem ? Dose the HDL Workflow Advisor have a Debug function that I can use to debug my design ?

Answer 1

[Kiran Kintali]

Hi Yuhwai, This is unexpected. Please report the issue to [e-mail] for further support.

[Yuhwai Tseng]

Thanks, Kiran.

Yuhwai.