how can i control subsystems from the Gui with checkboxes
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi guys,
i have different subsystems and i want to activate them with the checkboxs. But at first i have to couple these two Subsystems with each other. that is the first Problem with which simulink Block can I block these two Sebsystems, such that i can switch between these??? Maybe If action Subsystem????
THX
1 comentario
Kaustubha Govind
el 20 de Mayo de 2013
Does the GUI switch between the subsystems during simulation time, or only before simulation starts?
Respuestas (1)
Arunkumar Muthukumaran
el 19 de Dic. de 2015
If you using triggered subsystems, you can use GUI check box to activate/trigger the subsystem of your choice. If, at any time, only one of the subsystems should be active, then you can couple trigger of both subsystems with a switch and the control value shall be controlled by the GUI.
0 comentarios
Ver también
Categorías
Más información sobre Subsystems en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!