How to implement angular range constraints in SimMechanics 2nd Generation?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi
I'm trying to use SimMechanics 2nd Gen to model a revolute joint with angular ranges of +-90 degrees.
SimMechanics has a fixed angle constraint, but I would like to move my system till it reaches the limits and only then have the constraint engage.
Can you please advise how I can do this? I've successfully implemented this using the SimScape foundation library but I cannot correctly interface this to SimMechanics. The joint goes past the angular limits.
Any help would be appreciated.
Regards
Amir
0 comentarios
Respuestas (1)
Javaria Chiragh
el 24 de Mayo de 2014
There is an Angle Constraint block in Simscape/SimMechanics/2ndgeneration/Constraints but I dont know how to use it...!!
0 comentarios
Ver también
Categorías
Más información sobre Assembly en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!