Respondida
why does the car not start from the initial position that is from the track during simulation ?
It appears that you are not initializing the initial position of the vehicle correctly: https://www.mathworks.com/help/driving/r...

alrededor de 3 años hace | 0

Respondida
Custom scene simulation using unreal engine
This error appears because the vehicle is initialized outside the scene limits or if the scene has a hole in the ground. It may ...

alrededor de 3 años hace | 1

Respondida
MATLAB System block 'SCRReferenceApplication/Simulation 3D Vehicle with Ground Following/Simulation 3D Vehicle' error occurred when invoking 'stepImpl' method of 'Simulation3D
This error appears because the vehicle is initialized outside the scene limits. It appears that you are not initializing the ini...

alrededor de 3 años hace | 1

| aceptada

Respondida
power system control in simulink
This error is due to changes in the behavior of masks since this model was created in MATLAB R2009b. Please right click on t...

casi 4 años hace | 0

Respondida
Texas Instruments C2000 Processor, error: gmake: *** No rule to make target `all'. Stop.
Hi Yun, This is an error message that is thrown by the "make" (make/gmake) command. One cause for this error message could be t...

casi 4 años hace | 2

Respondida
Unable to extract simulink block paths in my model
On line 6, it should be 'SubSystem' instead of 'Subsystem'. Instead of using 'strcmp', consider using 'strcmpi' to prevent the c...

casi 4 años hace | 0

| aceptada

Respondida
Warning: The value of enumeration member 'VT_OK' differs from when the enumeration was saved. 'VT_OK' will be loaded with the new value.
These warnings can be resolved as follows: 1) Find the Simulink.Parameter objects or other data objects in the data dictionary ...

casi 4 años hace | 0

| aceptada

Respondida
Lane preview with Scenario Reader
Hi Andrea, the Scenario Reader produces information about lane detection as you have mentioned. In the Scenario Reader Block, it...

casi 4 años hace | 1