Respondida
Command Window, display line numbers?
Hi Joshua, There is no method to configure command window in such a manner that the line number is shown corresponding to ever...

más de 1 año hace | 0

Respondida
Cannot save model 'dfig' in the MDL file format because some of characters it contains are not valid in the current character encoding, 'US-ASCII'. Either remove these charac
Hi Khelifa, The error you are facing is because of the filename with which you are trying to save the model. Check the “Choos...

más de 1 año hace | 0

Respondida
How do I incorporate a feedforward control signal into an MPC block?
Hi Joe, According to my understanding, MPC is generally used in closed loop configuration and the “Measured disturbances” is u...

más de 1 año hace | 0

| aceptada

Respondida
Unable to get shared memory page. Make sure that your model either consists a Simulation step or an Analysis step block.
Hi Jie Tang, The error you are facing could be due to version mismatch between CANOE and MATLAB. The CANOE Blockset and CANOE...

más de 1 año hace | 0

Respondida
Solar PV System with MPPT Using Boost Converter
Hi Nishant, I believe you are referring to the following model present on the MathWorks documentation page - https://www.mathw...

más de 1 año hace | 0

Respondida
n-dimensional Polyhedron plotting using 2-dimensional plot commamnd
Hi Morteza, As per my understanding of the question you want to plot a “Polyhedron” in a 2-dimensional plot using only two of...

más de 1 año hace | 0