Supported Hardware and Required Software

Supported Hardware

The Communications Toolbox™ Support Package for USRP™ Radio supports Ettus Research™ devices listed in this table and has been tested on devices using Supported Daughter Cards. Support might also extend to other UHD™-based radios and daughterboards from Ettus Research.

National Instruments™ radios equivalent to the listed Ettus Research radios are also supported. For more information, see Mapping Between ER-USRP and NI-USRP Product Numbers.

Radio Series	Comment
USRP2™	—
USRP Bus Series (B200 and B210*)	Collectively referred to in this documentation as B-series.
USRP Networked Series (N210 and N200) from Ettus Research and USRP-292X and USRP-293X Series from National Instruments	Collectively referred to in this documentation as N2xx.
* SISO and 2x2 MIMO modes are supported.

Note

Starting in R2024a, live data I/O support for these National Instruments USRP radios has moved from Communications Toolbox Support Package for USRP Radio to Wireless Testbench™ Support Package for NI™ USRP Radios:

N300
N310
N320
N321
X300
X310

Supported Daughter Cards

These daughter cards are used with USRP2 and N2xx radios. Support might also extend to other UHD-based radios and daughterboards from Ettus Research.

DBSRX
DBSRX2
LFRX
LFTX
SBX
WBX
UBX
TVRX
TVRX2
XCVR2450

Firmware

The blocks and System objects use a specific version of the UHD driver. The FPGA binaries on your USRP radio must match the specific version of the UHD drivers supported by the current release.

MathWorks Products

The following MathWorks products are required for using Communications Toolbox Support Package for USRP Radio.

MATLAB^®
Communications Toolbox
DSP System Toolbox™
Signal Processing Toolbox™
Communications Toolbox Support Package for USRP Radio