Detect read before write

Description

Select the diagnostic action to take if the model attempts to read data from a data store to which it has not written data in this time step.

Category: Diagnostics

Settings

Default: Use local settings

Use local settings: For each local data store (defined by a Data Store Memory block or Simulink.Signal object in a model workspace) use the setting specified by the block. For each global data store (defined by a Simulink.Signal object in the base workspace) disable the diagnostic.
Disable all: Disables this diagnostic for all data stores accessed by the model.
Enable all as warnings: Displays diagnostic as a warning at the MATLAB^® command line.
Enable all as errors: Halts the simulation and displays the diagnostic in an error dialog box.

Note

During model referencing simulation in accelerator and rapid accelerator mode, if the Detect read before write parameter is set to Enable all as warnings, Enable all as errors, or Use local settings, Simulink^® temporarily changes the setting to Disable all.

You can use the Model Advisor to identify referenced models for which Simulink changes configuration this parameter setting during accelerated simulation.

In the Simulink Editor, in the Modeling tab, click Model Advisor, then click OK.
Select By Task.
Run the Check diagnostic settings ignored during accelerated model reference simulation check.

Command-Line Information

Parameter: ReadBeforeWriteMsg

Value: 'UseLocalSettings' | 'DisableAll' | 'EnableAllAsWarning' | 'EnableAllAsError'

Default: 'UseLocalSettings'

Recommended Settings

Application	Setting
Debugging	No impact
Traceability	No impact
Efficiency	No impact
Safety precaution	`Enable all as errors`