Main Content

Check size of junctions

Check ID: mathworks.jmaab_v6.jc_0907

Guideline: jc_0907: Size of junctions


Checks if the size of junctions is the same as the value set by the input parameter.

This check applies to the following target component:

  • Junctions in a Stateflow® chart.

This check requires a Simulink® Check™ license.

Check Parameterization

This check does not include sub-checks because the JMAAB modeling guideline provides only one sub ID.

For reference, the guideline sub ID(s) that are recommended for use by the JMAAB modeling standards organizations are:

  • JMAAB — a

You can configure the following input parameter to customize the check action:

Input ParameterValueDefault Value
Size of junctionsSize of junctions in a Stateflow chart14

Results and Recommended Actions

ConditionRecommended Action
Stateflow junctions are not set to the expected size.Change the junction size to the value specified by the Size of junctions input parameter.

Capabilities and Limitations

  • Runs on library models.

  • Analyzes content of library-linked blocks. By default, the input parameter Follow links is set to on.

  • Analyzes content in masked subsystems. By default, the input parameter Look under masks is set to all.

  • Allows exclusions of charts with all descendants.