Target NI USRP Radios Workflow

This workflow enables you to deploy hardware implementations of software-defined radio (SDR) algorithms on supported NI™ USRP™ radios.

The workflow enables you to:

• Use Simulink^® to design, simulate, and verify your user logic.

• Generate synthesizable HDL code for your user logic using HDL Coder™.

• Map your design to the target platform interfaces and integrate it into a reference design.

• Program the FPGA on your device.

• Generate scripts that provide the MATLAB^® code you need to connect to, configure, and control your device.

Before you begin, you must install and configure additional support packages and third-party tools by following the steps in Installation for Targeting NI USRP Radios.

The workflow steps are:

• Step 1 — Verify Radio Connection

• Step 2 — Set Up Third-Party Tools

• Step 3 — Prepare Hardware Model for Deployment

• Step 4 — Generate HDL Code

• Step 5 — Generate Bitstream and Program FPGA

• Step 6 — Run and Verify Hardware Implementation

.