Problem in linearizing a Simulink model
10 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Kobi Enciu
el 5 de Dic. de 2013
Editada: Guy Rouleau
el 6 de Dic. de 2013
I am trying to use linmod to extract a linear model of a non linear controller. I first trim the model in SIMULINK using the "trim" command, and receive correct results for my trim states ("xInitial") and model inputs ("FCS_Input") for a known output of the system. When I use linmod('mymodel',xInitial,FCS_Input) with "xInitial" & "FCS_Input" calculated by the trim function, I receive a "D" matrix that is identically zero. My model obviously has some linear i/o transmissions so that D must have some non-zero elements in it. Could the result I'm getting be due to direct connection of some of the inputs to terminator blocks? (I do this because the inputs to the model are vectors, where only part of the components are actualy used by my controller)
0 comentarios
Respuesta aceptada
Guy Rouleau
el 6 de Dic. de 2013
Editada: Guy Rouleau
el 6 de Dic. de 2013
It is difficult to say without looking inside the subsystem in your model.
A few tips: - If you have Simulink Control Design, there is a diagnostic window that can help you understand how each block is linearized and see which block is problematic.
- With linmod, the only tip I can give it to linearize pieces by pieces to see which block linearizes as zero.
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Trimming and Linearization en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!