![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/174635/image.png)
Problem with Enable subsystem in simulink
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I am simulating a Switched reluctance machine having 4 phases. Each phase is an enabled subsystem enabled by control signals generated from angle feedback. The problem is that even though the control signal is a pulse waveform varying from 0 to 1, the enable signal inside the subsystem is always shown to be 1 (observed from 'show output port'). This means the subsystem is always being enabled.
I am unable to resolve this issue. Please help asap.
0 comentarios
Respuestas (1)
Chandrasekhar
el 21 de Mzo. de 2014
Editada: Chandrasekhar
el 21 de Mzo. de 2014
The output of the enable subsystem holds the value even if the subsystem is disabled. If you want to reset the output value do as shown in figure below
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/174635/image.png)
Ver también
Categorías
Más información sobre Subsystems en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!