Matlab crashes when using ROS toolbox

2 visualizaciones (últimos 30 días)
Nathaniel Goldfarb
Nathaniel Goldfarb el 20 de Sept. de 2021
Movida: Remo Pillat el 11 de Mayo de 2023
I am using the ROS toolbox along with the responce tool kit to optmize my controller. IT work most of the time but sometimes i get the following error. The reson I did not save the raw output it because it matlab/simulink chrash into a loop seazes focus of my computer. it wont allow me to exit out or kill the program. I have to reboot inorder to kill the stop the program. Then when I resart I have to delete the matlabpref.mat file and relink my ROS messages.
Why is this happening and how do I prevenet it from happening? As you can see it just keeps spitting out the same error.
EDIT:
I was able to get my error file and I have attached it

Respuestas (1)

Abhijeet Gadkari
Abhijeet Gadkari el 27 de Sept. de 2021
Movida: Remo Pillat el 11 de Mayo de 2023
Hello Nathaniel,
I think ROS Toolbox features may not work with Parallel Computing Toolbox.
Due to the complexity of the setup, it is best to work with the Technical support team to resolve this. It will be easier to share the artifacts (like model, custom messages, etc.).
-Abhijeet

Categorías

Más información sobre Network Connection and Exploration en Help Center y File Exchange.

Productos


Versión

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by