Open wound/winding induction motor model in Simulink/Simscape
17 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Is there a open wound induction motor model available in Matlab simulink?
The requirement is similar as shown in the figure below.
Thank you.
0 comentarios
Respuestas (1)
Joel Van Sickel
el 29 de Nov. de 2021
The simscape motors have both ends of the stator exposed. This is mainly so you can decide if they are wye or delta connected, but they would allow for this type of setup as well. This exaple shows how the stator can change between wye and delta. However, this example uses a squirrel cage, so I have included a link to all of the motors which includes a wound rotor as well.
exposed stator windings example:
list of asynchronous machines including wound rotor:
Regards,
Joel
0 comentarios
Ver también
Categorías
Más información sobre Motor Drives en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!