Borrar filtros
Borrar filtros

Using shared configurations with configured hardware board

17 visualizaciones (últimos 30 días)
KristianT
KristianT el 7 de Mzo. de 2022
Respondida: Divya el 22 de En. de 2024
Hi,
I'm using a shared configuration as described here: https://www.mathworks.com/help/simulink/ug/referencing-configuration-sets.html
This seems to work fine until I set Hardware Implementation > Hardware board to "Raspberry PI". When I do this I get the following error when opening a model using the shared configuration :
------------
Parameter update is not supported for a configuration reference. Update parameter in the configuration set that it references.
Component:Simulink | Category:Model error
-----------------
And then I do not get hte Hardware tab I usually get when not using shared configurations.
Does anyone know why this isn't working?
Thanks in advance!
  1 comentario
Hangxu Li
Hangxu Li el 25 de Sept. de 2023
I also have the same problem when using 21a. But it works for 23a now. Did you find any solution to this problem?

Iniciar sesión para comentar.

Respuestas (2)

Nakul Khadilkar
Nakul Khadilkar el 11 de Mzo. de 2022
Hi Kristian,
Try setting the configuration parameter as below:
configurationSettings.set_param('Name', 'value');
configurationSettings’ should be a variable in your workspace and the variable’s name should match Referenced configuration set name in the Model Explorer.
-Nakul

Divya
Divya el 22 de En. de 2024
Hi,
need to take referenced Configuration object that model config references,and then set required parameter.
configSet = getActiveConfigSet(modelName);
referencedConfigObj = getRefConfigSet(configSet); % taking referenced Configuration object
set_param(referencedConfigObj, 'parameter_name', 'value');

Categorías

Más información sobre Run on Target Hardware en Help Center y File Exchange.

Productos


Versión

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by