Im trying to delay a signal in time?

7 visualizaciones (últimos 30 días)
Miguel Albuquerque
Miguel Albuquerque el 10 de Mzo. de 2022
Comentada: Miguel Albuquerque el 4 de Mayo de 2022
Hey guys, this is probably very easy but i can't figure it out.
Im trying to delay a QPSK signal in time , a few seconds.
Variables:
Ns=Nb/2
fc=2.45e9;
t=linspace(0,Ns*Tb,length(Reference_Signal));
Reference_Signal is a 1x769600 double signal.
Im trying to delay this reference signal by doing this:
Surveillance_Signal= delayseq(Reference_Signal,3,fs); But this new signal is 0 in all columns.
Thank you

Respuesta aceptada

Kiran Felix Robert
Kiran Felix Robert el 15 de Mzo. de 2022
Hi Miguel,
I am not sure about your 'fs' value, but according to the delayseq documentation, when you specify an 'fs' argument the delay units are in seconds.
Try checking the Survielence_Signal after 3 (your delay) seconds of abolute time.
Total time of the signal present = (length of signal) * (1/fs),
If the total time of signal is less than 3, then output will be zeros in all columns.

Más respuestas (0)

Categorías

Más información sobre Spectral Measurements en Help Center y File Exchange.

Etiquetas

Productos


Versión

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by