Simulink coder and disabled subsystems
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I'm trying to generate code from a Simulink diagram which contains an enabled subsystem. The enable is tied to a workspace variable that is always 0 (the subsystem should never be enabled). Still, it seems that the coder tries to generate code from this system. Why is this happening? Can I stop it from happening?
Thanks
0 comentarios
Respuestas (2)
Paolo
el 7 de Abr. de 2015
I have the same problem. It seems that the optimization "Simulation and code generation -> Block reduction" doesn't properly work in this case.
0 comentarios
TAB
el 7 de Abr. de 2015
Check if
Optimization > Inline Parameters
option is selected.
If this option is not selected, then Simulink will assume every parameter as tunable and it will be included in code independent of its value.
0 comentarios
Ver también
Categorías
Más información sobre Simulink Coder en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!