Modelling a voltage controlled current source
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi!
I have a school project, where i need to simulate the blindig of protecion and sympathetic tripping defense problems. I'd like to model a current source that responds to the voltage drop caused by a fault. I'm using the controlled current source block for it. The constant block has the effective power value which gets divided by the rms value of the voltage so it should give me the current. My problem is that when i connect this block to my circuit it doesnt do anything. I'd like to ask what is the problem with my model?
1 comentario
Respuestas (1)
Joel Van Sickel
el 13 de Jun. de 2022
This looks like it creates an algebraic loop. It's easier to do this type of modelling using simcape: https://www.mathworks.com/learn/tutorials/circuit-simulation-onramp.html
and use this block to model a dynamic load: https://www.mathworks.com/help/physmod/sps/ref/dynamicload.html
Regards,
Joel
0 comentarios
Ver también
Categorías
Más información sobre Electrical Sensors en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!