simulink model of wind turbine lqg regulation does not work properly
5 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I have simulated the following block diagram with consists of a wind turbine state space with kalman filter, full state feedback and full state observer suggested by an article which I uploaded.
I don't know why I don't get the same output as the article! This is my simulink simulation:
This is my output:
This is the output in the article:
Also I'm not sure about where should I put the wind speed? I would really appreciate if you could help. I have attached my simulink file and the article.
0 comentarios
Respuestas (1)
Sam Chak
el 1 de Ag. de 2022
I suspect that the instability is caused by the signs in these two summation blocks:
If you look into the closed-loop system, the feedbacks are of minus signs.
I guess you tried to follow the LQG block diagram in Fig. 1, but sometimes, some publications contained errors and the production crew were unable to fix the technical-related matters. Moreover, the paper has only one author.
Ver también
Categorías
Más información sobre Wind Power en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!