Do you know how to remove some points from point cloud data?
11 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Motoki Hatsuda
el 9 de Sept. de 2022
Comentada: Motoki Hatsuda
el 16 de Sept. de 2022
Hello, everyone.
I am a MATLAB newbie!
There is noise in the point cloud data observed by lidar, and I want to remove it somehow, but I don't know how.
Is there any way to do this?
0 comentarios
Respuesta aceptada
Cris LaPierre
el 9 de Sept. de 2022
Perhaps the pcdenoise function? Go through the examples on that page to see if it does what you want.
5 comentarios
Cris LaPierre
el 13 de Sept. de 2022
It's hard to say by looking at your image. The easiest way to find out would be to try it out and see if the results are what you need.
Outliers tend to be noise/spurious data, and not valid but unwanted data, like the pedestrians here. My suspicion is that, if you want to remove a certain type of object from your point cloud, you probably have to first identify the various obejcts in your point cloud, and then remove the ones you do not want.
This is not an area I hvae a lot of experience, so perhaps pointing you to this eample can serve as a starting point?
Más respuestas (0)
Ver también
Categorías
Más información sobre Labeling, Segmentation, and Detection en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!