How to change PIN Mapping in Embedded Coder for the c2000
3 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Hi there, I have a costum Controlerboard using the F2838x µC from TI. I would like to use GPIO131 for the Ethernet connection for Example. How can i assign a PIN mapping like in the TI Sysconfig to the Embedded Coder? Or can I assign a sysconfig file to embedded coder somehow? Thanks
0 comentarios
Respuestas (1)
Abhishek Gota
el 6 de Dic. de 2023
Hi xone_92,
Assuming you are using R2023b integration of "TI sysconfig" with "C2000 Microcontroller Blockset " is not supported . GPIO configuration required for ethernet communication is automatically taken care by C2B during code generation requiring no additional configuration outside simulink model .
Did a quick check on TI F2838x TRM and do not see muxing capability of GPIO131 to be used as one of the ethernet lines , Any reason to use GPIO131 ?
I have c2000 documentation for cortex-m4 for additional reading.
Hope this helps
Thanks
Abhishek
0 comentarios
Ver también
Categorías
Más información sobre Deployment, Integration, and Supported Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!