Run a function in given time moments.
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Valeriy
el 5 de Nov. de 2023
Movida: Dyuman Joshi
el 7 de Nov. de 2023
Hi all
I need to run MyFunction.m tomorrow starting from 14:20:00 and repeat it 10 times with periodicity of 5 minutes. How to proceed?
Thanks for help
0 comentarios
Respuesta aceptada
Walter Roberson
el 5 de Nov. de 2023
MATLAB does not support that.
The closest to that is that timer supports a start delay -- so you could calculate the time difference between now and 14:20 tomorrow and use that as the delay. But that is going to not going to start exactly on time -- and if you exit MATLAB in the meantime then the timer will not run, and will not start up again if you go back into MATLAB.
3 comentarios
Walter Roberson
el 5 de Nov. de 2023
I would suggest writing a control table to a file indicating the date/time when each event is to start.
Then, periodically:
- read the file
- schedule a timer object (using relative time) for any event that is due to start within the next two refresh cycles; if there is already a timer for the event, check to see whether the start time delay needs to be updated
This scheduling should also be done upon starting MATLAB
Creation of a new event should be accompanied by writing the event to the control file and then running the check cycle again.
Más respuestas (0)
Ver también
Categorías
Más información sobre Startup and Shutdown en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!