Is it possible to use a parameter within the "To Workspace" block?
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
I have a "ToWorkspace" block inside a masked subsystem. I would like to change the name of the variable (where the data is saved) based on a parameter of the subsystem mask. Is it possible to do this somehow?
Thanks in advance for whoever helps me.
0 comentarios
Respuestas (1)
Fangjun Jiang
el 9 de Abr. de 2024
Editada: Fangjun Jiang
el 10 de Abr. de 2024
I remember answering the same question before. The answer is "No" by value passing, but you could do it using set_param().
For MyValue=1, the value (1) of the variable name "MyValue" is passed into the mask workspace. Inside the masked subsystem where "MyValue" is used, it is using the value (1), not the name "MyValue".
But for "To Workspace" block, the variable name "name" itself is used, not the value of the variable name "name".
This sounds confusing but it is the case for a few similar parameters for other blocks.
If you are open to write some lines of code in the call-back of the mask, you could use set_param() to set the variable name of the To Workspace block, based on the name provided at the mask dialog.
What I would suggest is to use other signal logging methods, not to use "To Workspace" block. Basically, select the signal line, right click, select "Log Selected Signals".
1 comentario
Fangjun Jiang
el 10 de Abr. de 2024
@Simone Bergadano, I updated the answer to include using set_param() as a way to implement what you want.
Ver también
Categorías
Más información sobre Subsystems en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!