Example c2000 concerto on the leds
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Hi,
I tried this example of the LEDs on Matlab.
I have a problem in managing the LEDs . From datasheet card there is no correspondence with the LEDs indicated by example. Infact there is led 1 with GPIO 70 but not LED 2 .
Also, if I try to use the C28x processor to turn on the LED 3 ( GPIO71 ) nothing happens .
Who can help me ?
Thank you
Luigi
1 comentario
Andres
el 14 de Jun. de 2016
I have the same issue. I tested the board using CCS Studio and LED2 correspond to GPIO 70. So I think the model is ok.
Also If I follow the M3 example everything works . The issue comes when you try to load the C28x model into the processor. Is not loading at all. These are the last two lines I got form the diagnostic viewer. ### Successful completion of code generation for model: led_blink_f28m35_c28 Build process completed successfully ------ I think it should attempt to load and Run but nothing happens.
Respuestas (1)
Andres
el 15 de Jun. de 2016
This Worked for me :
Reinstall the support packages for C2000 Concerto
Install the latest version of ccs studio.
Change in configuration parameters in the code generation pane, the Toolchain settings , Toolchain = Texas Instruments Code Composer Studio V6 (C2000)
I hope this can help.
0 comentarios
Ver también
Categorías
Más información sobre Deployment, Integration, and Supported Hardware en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!