- Use 0.000000001 or so instead of 0 in Integrator initial condition box. Try reducing or increasing number of zeroes until your model runs fine.
- Use a delay block in front of "division" block.
Derivative input is Inf
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Ibrahim Seleem
el 8 de Sept. de 2015
Comentada: Sofia Carvalho
el 12 de Abr. de 2017
Hi,
I face a Simulink problem at the input of the integration block, which is:
Derivative input 1 of 'test_ahmed/Integrator' at time 0.003375 is Inf or NaN. Stopping simulation. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
However,the input of the integration block is not infinity according the scope.
The model belongs to sliding mode control of biped robot in single support phase.
attached with the message simulink model..
Thank you!
0 comentarios
Respuesta aceptada
MUHAMMED FASIL
el 28 de Sept. de 2015
Editada: Walter Roberson
el 19 de Oct. de 2015
Error with attached model.
3 comentarios
MUHAMMED FASIL
el 19 de Oct. de 2015
Sofia Carvalho
el 12 de Abr. de 2017
I have a similiar error, I guess: https://www.mathworks.com/matlabcentral/answers/334702-solar-pv-panel-simulink-solver-error
Más respuestas (0)
Ver también
Categorías
Más información sobre General Applications en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!