Send a sine wave out of matlab to arduino

I want to output the values from a sine wave to generate pulses for an h-bridge but don't know hot to send them one by one. is it possible for some help?

Code i did till now is attached below:

arduino=serial('COM2','BaudRate',9600);
fopen(arduino);
frequency = 1; % required frequency
period = 1/frequency; % required period
%amplitude = 127 ; % required amplitude
phase = 0; % required phase angle
offset = 127; % required DC offset
t = 0:0.00001:2*period;
output = 127 * sin(2*pi*frequency*t + phase) + offset;

Answer 1

[Gautam Vallabha]

I assume you want to output the sinusoid values to an "analog output" (PWM) pin.

Take a look at MATLAB Support Package for Arduino. It allows you to send commands from MATLAB to Arduino, e.g.

 a = arduino('COM9');
 a.pinMode(13,'output'); % digital output
 a.pinMode(9,'output'); % "analog output" (PWM)

 % output the digital value (0 or 1) to pin 13
 a.digitalWrite(13, 0)

 % ouptput value on digital (pwm) pin 5 
 a.analogWrite(9, 120)

(The above code is from examples/example_io.m in the support package).