Simulink PIL blocks.

I am using matlab R2011a , CCS v3.3 , c6713. I have kept a part of my simulink model inside one subsystem & converted it into a PIL block. Then I connected the PIL block inplace of the subsytem.. But when I run the model I am getting the following errors.

 1) Error in 'notch/Subsystem2' while executing C MEX S-function 'Subsystem1_pbs', (mdlOutputs), at time 0.0.

 2) An error occurred while calling into the SIL or PIL target connectivity implementation.

 3) RunToHalt: Timed out waiting for CCS to confirm completion.

why am I getting these errors ???

Answer 1

[Kaustubha Govind]

Try increasing the "Maximum time allowed to complete IDE operation" on the IDE Link pane of the Configuration Parameters window?

[Sujeet Kumar Padhi]

NO ma'am I am still not getting the result.

Now I am getting the following errors :

1) Error in 'notch/Subsystem2' while executing C MEX S-function 'Subsystem1_pbs', (mdlOutputs), at time 0.0.

2) An error occurred while calling into the SIL or PIL target connectivity implementation.

3) RunToHalt: Timed out waiting for CCS to confirm completion.

why am I getting these errors ???

4)Error in 'uwbtf/Subsystem' while executing C MEX S-function 'Subsystem_pbs', (mdlTerminate), at time 0.0.

5) An error occurred while calling into the SIL or PIL target connectivity implementation.

6) RunToHalt: Timed out waiting for CCS to confirm completion.

[Kaustubha Govind]

How much did you increase the timeout by? Also, have you configured the target to use DSP/BIOS as OS? If yes, also try with "None" as OS.

[Sujeet Kumar Padhi]

I increased the time to 20,50,100,200. I was not using any OS . I have tried with DSP/BIOS but after the building of the project when I connected the PIL & run the model...Time starts from T = 0.00 & it goes on increasing but I am not getting any output.(It didnt show any error this time).

I was getting errors when I didnt use any OS. But when I changed the timeout, now its not giving any errors but I am nt getting any result evenif the model runs for a long time... ???

[Kaustubha Govind]

Hmm.. I don't know what you can do to get this working at this point. Please try contacting MathWorks Tech Support if you have a license that is on maintenance?