code c generation in matlab

Hello. When I create a Vivado project in MATLAB2017a using 'hdl workflow advisor', for "HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364" does not give me the C code in SDK. That is, when I put it in Vivado, that code is not.please help me. thanks

[mehmet]

can you solve tihs problem ?

Answer 1

[Yash]

Hi Mohsen,

Firstly, please verify that the host radio communication is set up properly as given in the following link:

https://www.mathworks.com/help/soc/ug/hardware-and-software-requirements.html

Also, please follow the given example step by step without making any changes to the procedure:

HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364

Hope this helps!

[mehmet]

Hi Yash ,

I even ran it on a zcu102 + fmcomms3 card and sent and received hello world. But the SDK (vitis) codes were not created.