PIL simulation mode using LEGO EV3

Each time I run my model in PIL mode using LEGO EV3 I get the following Error. "The configuration parameters for this model do not support the following connectivity configurations: Raspberry Pi, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial)"

While the External mode is working very well.

Answer 1

[Abhinav Aravindan]

Hi Amin,

Code Verification and Validation with PIL does not seem to be supported for the “LEGO MINDSTORMS EV3 Hardware” due to which you are facing the error. However, you may perform “Monitor and Tune (External Mode) simulations” to tune parameters and monitor a model running on your target hardware as well as “Run Model on EV3 Hardware” using “Build, Deploy & Start”.

For further information, please refer to the links below:

• https://www.mathworks.com/help/simulink/supportpkg/legomindstormsev3_ug/tune-parameters-and-monitor-data-in-a-model-running-on-target-hardware.html
• https://www.mathworks.com/help/simulink/supportpkg/legomindstormsev3_ug/create-and-run-an-application-on-lego-mindstorms-ev3-hardware.html