Singularity error - Simulink

79 visualizaciones (últimos 30 días)
Harvijay Raj
Harvijay Raj el 13 de Feb. de 2018
Respondida: Suhan el 19 de Feb. de 2018
An error occurred while running the simulation and the simulation was terminated Caused by: Derivative of state '1' in block 'XXXXXX/Receiver/pre-amp/CTLE mode 2/Transfer Fcn15' at time 3.3003349235944607E-9 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)
Please help.
  5 comentarios
Harvijay Raj
Harvijay Raj el 13 de Feb. de 2018
I am working on Serdes model, I have quite a few Xfer func that you might be interested in seeing.
Harvijay Raj
Harvijay Raj el 13 de Feb. de 2018
So r u from Mathworks? R u setting up some remote debug session?

Iniciar sesión para comentar.

Respuestas (1)

Suhan
Suhan el 19 de Feb. de 2018
Hi,
The singularity issues occur due to model instabilities. Instabilities may occur in a model due to a wide variety of reasons and one of them is the reference is too quick that the plant does not have enough time to respond and runs into singularities. This can be eliminated by putting in a filter on the reference signal.
Below is information on three tools that may assist you in further improving the model stability, if you are not already familiar with them:
1. Solver Profiler: The Solver Profiler can help you visualize your model dynamics and see where they may be unstable. Using the Solver Profile is described at this link: https://www.mathworks.com/help/simulink/ug/examine-solver-behavior-using-solver-profiler.html
2. Log the Simulink states, so you may view their values after running the simulation (perhaps stop the simulation before the error or use the above approach to remove the error): https://www.mathworks.com/help/simulink/examples/logging-states-in-structure-format.html
3. Use Stepping Options to pause the simulation and view signal values before the error occurs: https://www.mathworks.com/help/simulink/ug/simulation-stepper-interface.html

Categorías

Más información sobre General Applications en Help Center y File Exchange.

Etiquetas

Productos

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by