Temperature Control using PID via Simulink
20 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I found that after i insert PID parameters in the model, the lightbulb keep on flickering due to fluatuated duty cycle. Also, i found that no improvement is done using the PID parameters . Does this means PID dont have any function at all in improving the lightbulb performance? Theorectically, PID suppose is better than using ON/OFF and Deadband as it could reduce flickering. The results obtained is opposing the theory. Whats wrong with the model build as shown in Figure below?
0 comentarios
Respuestas (1)
Ege Keskin
el 3 de Feb. de 2019
You might achieve better results by directly using the PID block on simulink.
0 comentarios
Ver también
Categorías
Más información sobre PID Controller Tuning en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!