how to control dc motor by matlab gui with adafruit motorshield V1?

please help to control dc motor by matlab gui with arduino adafruit shield V1

[amin ya]

Any solution?

Answer 1

[Tony Lennon]

Please take a look at this video. https://www.mathworks.com/videos/using-matlab-and-arduino-for-motor-control-100737.html

It's not exactly the same HW setup, but close.

[amin ya]

This does not work! Motor Shield V1 requires legacy Matlab's Arduino support package and can't be installed beside new Matlab's Arduino support package.

[Madhu Govindarajan]

Adafruit Motor Shield V1 has been discontinued for a while and hence was never supported by the official MATLAB Support package. However, if you are interested here are a set of instructions that shows how to create your own custom support along with an example at the bottom of that page - https://www.mathworks.com/help/supportpkg/arduinoio/ug/custom-arduino-add-on-device-library-and-code.html

If you end up creating an add-on, please share with community using File Exchange.

Regards,

Madhu