Simulink - F28335 eQEP block is not working properly
4 views (last 30 days)
Hi again everyone;
This time I want so ask something about eQEP module for F28335 processor. However, before problem, let me introduce my tools:
- Matlab: R2019A and Embedded Coder Support Package v17.2.6
- Code Composer: CCS7
- CPU: F28335 processor with 140MHz CPU Clock and 40MHz Oscillatory clock
My aim was reading an incremental encoder –which is attached at the back of an electric motor- using eQEP module. First, in order to check whether hardware installed correctly or not, I wrote custom code in Code Composer Studio. This code had two main parts in order to read encoder, which were initializing and reading respectively. By this way, I read encoder properly. The code segments are presented in Picture 1 and picture 2.
On the other hand, I tried the same solution in Matlab/Simulink. I didn’t change any hardware componentand used same gpios for eQEP module, which are 50-51-52-53. Problem is eQEP block did not give any output. Even noise or any meaningless data was not recieved, just 0 came. While configuring eQEP, I used following configurations(I just used General and Position Counter tabs - other tabs are unchecked.)
My question is what could be possible reasons for this situation? Am I missing any clocking issue, register issue or some interrupt service routine issue? Actually, I compared derived code and custom code, I could not see any considerable differences but I am not sure.
Thanks in advance, best regards;