Field oriented control on Zynq Zedboard without the FMCMOTCON2 module.
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Zaeem Gauher
el 21 de Jun. de 2019
Respondida: Joel Van Sickel
el 18 de Ag. de 2020
I am trying to implement the Field oriented motor control example found here: https://www.mathworks.com/help/supportpkg/xilinxzynq7000ec/examples/field-oriented-control-of-a-permanent-magnet-synchronous-machine.html
I do not have the FMCMOTCON2 driver module that comes with the kit ( I have the Zedboard and the Dyno). Can I use another driver board such as the Enclustra FMC DR2? If so, do I need to change any parameters in the simulink model for this example?
0 comentarios
Respuesta aceptada
Joel Van Sickel
el 18 de Ag. de 2020
Hello Zaeem,
You can use the fundament control algorithm with any driver, assuming that driver is appropriately speced for your system. Assuming you are only changing the driving hardware, most parameters in the simulink model will not need to change. However, you will need to investigate the interface to the new driver and make sure that all signals are scaled/typed appropriately and the signals go to the correct i/o channels, as the interface is probably somewhat different.
Regards,
Joel
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Hardware-in-the-Loop Simulation with Simulink Real-Time en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!