Ardunio not detected by Analog input recorder

The analog input recorder works very good for me and it detects different data acquisition devices like National Instrument boards and the ADALM1000.

I can connect to my Arduino Uno in MATLAB (and also with the Arduino IDE, of course), but the analog input recorder doesn't recognize the Arduino.

Is this a more general issue? Do I need to configure the Arduino in a special way?

I should mention, that interfacing with the Arduino(s) (Uno, Nano etc.) with code, i.e. MATLAB's arduino function works perfectly well and I am able to record input or generate output.

What additional diagnostics could I run in order to pin down the problem?

[Mohammad reza Nejati]

I have the same problem. Does anyone have any solution?

Answer 1

[Nikhil Sonavane]

Check if your device is supported by the Data Acquisition Toolbox of MATLAB. You may refer to the following documentation for more details-

https://www.mathworks.com/help/daq/install-hardware-support-package-for-vendor-support.html

[Nicolas Bourbaki]

Thanks a lot for your answer. I should have mentioned that interfacing with the Arduino(s) (Uno, Nano etc.) by code (i.e. the MATLAB's arduino function) works absolutely fine and I can nicely recorder input or generate output.

I did install the Arduino Hardware Support Package, but the Analog Input Recorder would not even list one of the Arduinos.

Answer 2

[Aezaz Hasan]

How to get Devices in Analog Input Recorder.