Using external Motor Driver C-Code in Simulink

1 visualización (últimos 30 días)

tired el 9 de Jun. de 2020

Editada: tired el 9 de Jun. de 2020

Hi,

so i'm trying to utilize external c-code for the motor driver powerstep01.

I've tried to include the necessary .h and .c files to use the c-code via the ccaller-block, but i'm still not able to build the code.

I'm using Matlab R2018b, STM32 Mat-Target, CubeMX and SW4STM32.

The stepper motor driver software expansion for STM32Cube i'm using is X-CUBE-SPN3.

It would be nice to get some general information about which steps i should be following to generate the code.

Thanks for your Help

Best regards Tom

Más información sobre STMicroelectronics Discovery Boards en Help Center y File Exchange.

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by