Borrar filtros
Borrar filtros

Problem Saving Workspace - No Error Message

11 visualizaciones (últimos 30 días)
kellie
kellie el 17 de Dic. de 2012
Editada: Walter Roberson el 3 de Mzo. de 2016
Hi,
I have done some work which leaves me with several cell structures that I would like to save. I had hoped to save the workspace, but when I try to do this there is a problem - I go about saving the file like normal; however, it never saves. There is no error message so I am at a loss for what to do.
Thank you, -Kellie

Respuestas (4)

Matt Fig
Matt Fig el 17 de Dic. de 2012
Editada: Matt Fig el 17 de Dic. de 2012
Of course, it would be immenseley helpful, and might actually allow a solution to be put forward, if you describe in detail what is meant by "like normal" when you save your wok. A few lines of code should suffice...

Walter Roberson
Walter Roberson el 17 de Dic. de 2012
Are you getting past 2 gigabytes? If you are, then you need to use the -v7.3 flag when you save.

kellie
kellie el 17 de Dic. de 2012
@Matt
Sorry. 'Like Normal' is just me either:
(1) typing save(FileName)
(2) File->Save Workspace As
@Walter
How can I tell if I'm past 2 gigabytes? In the simplest case, I am just saving a single array of doubles, so I am doubtful it is that big.
Thank you both.

capraro12
capraro12 el 2 de Mzo. de 2016
Editada: Walter Roberson el 3 de Mzo. de 2016
I have encountered a similar scenario:
'File->Save Workspace' and 'Ctrl+S' strategies repeatedly failed to yield a saved file (attempting for a 20 MB workspace), despite the anticipated sequence of events occurring smoothly for these actions without an error message.
In my case, however, typing save(FileName) did work.

Categorías

Más información sobre Filename Construction en Help Center y File Exchange.

Etiquetas

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by