empty signal coming into minimum block problem
4 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
I have a Find non-zero block connected Min block. Find non-zero outputs a variable size matrix that shrinks for one element in every step because this is part of a switch off algorithm based on minimum value. Because switch off is in loop with non-zero block this means that in final step when everything is switched off the non-zero sends and empty signal to Min block and this gives error "The signal at input port 1 of 'Min' cannot have an empty size" I would like to simulation to finish by terminating the swich off operation and ending the algorithm without this error.
0 comentarios
Respuestas (2)
Kaustubha Govind
el 31 de En. de 2013
Not sure if this is what you're looking for, but you can use the Stop block to stop simulation based on an input condition.
0 comentarios
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Productos
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!