How to configure the FMCOMMS5 Transmitter & Receiver block to transmit data through a specific channel?
2 visualizaciones (últimos 30 días)
Mostrar comentarios más antiguos
Xiaoxiao Liu
el 12 de Oct. de 2020
Comentada: Arash Jafari
el 28 de Jun. de 2022
Hi, I'm running the model "HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364". The default channel used in FMCOMMS5 block is channel 1 (TX1A_A & RX1A_A), and it works fine with the default value. Now I try to transmit and receive data through channel 2 (TX2A_A & RX2A_A), so I change the parameter "Channel Mapping" in FMCOMMS5 Transmitter & Receiver block into "2", as indicated in the following instruction:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/377841/image.png)
However, in this case, I cannot receive anything in the diagnostic viewer. What's wrong with the configuration? Is there anything else I need to configure?
0 comentarios
Respuesta aceptada
Lakshmi Bugide
el 15 de Oct. de 2020
Hi,
By default, the model "HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364" is designed to work with Channel1 of the device. If you want to transmit and recieve with channel 2 , you need to map the Hardware generation Model (HDL_QPSK) interfaces to Channel2 Target Platform interfaces instead of Channel1 interfaces. You have to change the interfaces at Step 1.3 Set target Interface of IP Core Generation Workflow/https://ww2.mathworks.cn/help/supportpkg/xilinxzynqbasedradio/ug/hw-sw-co-design-qpsk-transmit-and-receive-using-analog-devices-ad9361-ad9364.html;jsessionid=b5a8b838ef5b95014eff2f7ae46c#d122e9019.
2 comentarios
Arash Jafari
el 28 de Jun. de 2022
Hello Liu,
Please check the UART console of the carrier board during boot up, if the RX digital tune failed!
Kind Regards
Arash
Más respuestas (0)
Ver también
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!