How do I generate pulses from the block PWM Generator to operate the switches if they are more than four?

9 visualizaciones (últimos 30 días)
Hello every one
I hope to find any ideas for my inquire.
my question as in the picture there are two models, the left one five-level cascaded with PWM pulses to operate the switches, and the right one is a boost converter with a
PID controller to operate one switch. so here I want to use PI control to on five-level cascaded model but after PI block
How do I generate the pulses for 8 switches to operate them?
  2 comentarios
Hyunuk Ha
Hyunuk Ha el 30 de Dic. de 2020
We have several methods:
  1. Simscape Electrical has PWM Generator(Multi-level) blk. : https://www.mathworks.com/help/physmod/sps/powersys/ref/pwmgeneratormultilevel.html?searchHighlight=mmc&s_tid=doc_srchtitle This generates multi-level PWM signals.
  2. You can refer to the 'Modular multi-level converter' at : https://www.mathworks.com/help/physmod/sps/ug/modular-multi-level-converter-mmc.html?searchHighlight=mmc&s_tid=doc_srchtitle Your left circuit is similar with MMC, so please visit above example.
  3. Additional comments : How about tie the switching devices with one blk. : https://www.mathworks.com/help/physmod/sps/powersys/ref/fullbridgemmc.html?searchHighlight=mmc&s_tid=doc_srchtitle
Hope this helps,
Hyunuk

Iniciar sesión para comentar.

Respuestas (1)

Manas Meena
Manas Meena el 5 de En. de 2021
As answered on your other question by Joel. If none of the above workarounds help you, you will have to write your own algorithm to convert the scalar output into separate duty cycles.

Comunidades de usuarios

Más respuestas en  Power Electronics Control

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by