Can someone help me run the simcape BLDC simulation with my values?

When working with the default values, the Pid controller with and without PWM works fine, but when i use my other BLDC values , it doesn't simulate properly.

The model i used

https://uk.mathworks.com/videos/motor-control-part-2-bldc-motor-control-1567761327790.html?s_tid=vid_pers_recs

The values I used have been attached in the pdf

Answer 1

[Sabin]

This particular paramaeterization of Maxon ECXTORQUE_22L is available in the List of Pre-Parameterized Components in Simscape Electrical. The part can be selected from the BLDC block mask. This way you can doiuble check your model.

[Yashvi Srivastava]

Hi, Quick question:

Is there any pre-paramaeterization about "Flipsky Sensored Outrunner BLDC Motor Battle hardened 5048 200KV 1300W"? When I tried to edit the exisiting BLDC model provided by "https://www.mathworks.com/help/sps/ug/brushless-dc-motor.html", I was not able to see the help section to understand the given parameters:

Like current loop time constant, etc,