Simulink Fixed point to Floating Conversion

I am using fixed point designer to convert a single floating type value to a 32bit fixed point value. How to I convert the fixed point type back to floating type. I tried the below but that only gives the integer component of the floating point number. I also want to get back the fractional component. I tried changing the convert block's output type to be RWV instaed of the SI to no success.

Answer 1

[Andy Bartlett]

Notice the "(SI)" shown on the icons of the data type conversion blocks.

That means the block is using the less common "Stored Integer Value Mode", instead of the default "Real World Value Mode".

(SI) mode ignores scaling and is not what you want in your use case.

If you reconfigure the data type conversion blocks to use

Input and output to have equal: Real World Value (RWV)

then you'll get the behavior you are seeking.

[Mashrur Alam]

Thanks! This worked.